HHIP Flute Cobalt Fine-Pitch Roughing End Mill, 1/4" x 3/8" x 1/4" Cutting Dia, 3/8" Shank, Cutting Length, OAL 4 Teeth

HHIP 1/4 X 3/8 X X 4 Flute M42 Cobalt Fine-Pitch Roughing End Mill Cutting diameter is 1/4". Shank diameter is 3/8". Cutting length is . Overall length is . Ground From Solid M42 Blank. 8% cobalt. Center cutting. Low co-efficient friction. The pressure of the cut is distributed over many teeth. Recommended for high production milling in difficult-to-machine materials such as inconel, hasteloy, titanium alloys and other materials up to RC 40. With a Weldon flat, a flat section on the tool shank, used to hold the tool in place by set screws within the body of the holder.

Ground From Solid M42 Blank,8% cobalt,Center cutting,Recommended for high production milling in difficult-to-machine materials such as inconel, hastily, titanium alloys and other materials up to RC 40,The pressure of the cut is distributed over many teeth

Cutting edge material	Cobalt
Size	1/4" Cutting Dia, 3/8" Shank, 1-1/4" Cutting Length, 3-1/16" OAL
Drill bit & set type	Drill Bits
Brand	HHIP
Material	Cobalt
Has written warranty	No
Model	5823-0251